If you are looking for an easy way to get more power out of your 2015 Jeep Wrangler look no further than DiabloSport and their new Power Programmer and aftermarket PCM for the 3.6L Pentastar engine. This easy to install programmer and PCM will ensure peak performance while enhancing throttle response, cleaning up automatic shifting, and raising rev limiters. The new tuning for your Jeep will unlock an additional 20 hp and 25 lb-ft. of torque over your stock calibration.
Official Release:
DiabloSport can now optimize the drivability of your 2015 Jeep Wrangler with a 3.6L Pentastar with Power Programmer & Aftermarket PCM! DiabloSport’s tuners can add horsepower and torque to your 3.6L engine like no other performance mod available. DiabloSport made huge power gains with the 2015 JK on their Super Flow Chassis Dyno, indicating the optimal tune for 93 octane. They optimized the factory timing and fueling maps through hundreds of dyno pulls to ensure peak performance. Their tunes enhance throttle response, clean up automatic shifting, and raise rev limiters in an effort to let your jeep “Climb over anything”!
The DiabloSport inTune-DCX & Trinity tuners let users adjust a host of parameters in their Jeep. The tuners calibrate the speedometer for larger tires and gears, adjust the jeep’s idle for aftermarket accessories like winches and lights, dial in your throttle response with “throttle booster technology”, and you can even modify performance parameters like timing/fueling/idle and more!
They have created a solution to tune the 2015 Jeep Wrangler, but it is a little different than using a typical tuner. Tuning it now requires an aftermarket PCM as well as the tuner in order for you to install aftermarket calibrations. We can provide you all the necessary equipment (PCM and Tuner) that allows you to install a tune on your vehicle. DiabloSport offers aftermarket modified PCMs for $599, just provide them with your Jeep’s VIN and Odometer mileage using this order form. If you need a DiabloSport inTune DCX or Trinity-they are even giving discounts on buying the PCM and a tuner at the same time($899 inTune + PCM, or $999 Trinity + PCM)! You then replace your Jeep’s stock PCM with the aftermarket Diablo PCM through a simple process that should only take about ten minutes. Once you have replaced the factory PCM, you can install a tune with your DiabloSport tuner and you are ready to go! If you need to go to the dealership for service work, re-install your original PCM and the dealer will not be able to tell that you have done any modifications. Basic installation instructions for the PCM swap are available here.
Features:
- An additional 20 HP and 25 Ft. Lbs of torque over your stock calibration
- Enhanced throttle response
- Ability to raise rev limiters