There are few things in a dyno room, or under the hood, more annoying than a leaky AN fitting. When they work properly, AN fittings (and flare fittings in general) are ingenious, fluid-tight couplings that require a minimal amount of torque and no external gaskets to seal. The downside to them, is that the mating surfaces require a decent finish on both sides of the equation, making them more susceptible to leaking when damaged. Enter Koul Tools Fitting Fixer.
When you have a leaking, damaged fitting, no amount of hulking out will make a poor connection seal. Quite the opposite, actually, as overtightening an aluminum AN fitting can further damage, or even destroy the fitting. The only solution is to re-machine the mating surfaces. For female fittings, Koul Tools makes the P-51 Sureseat lapping tool that we’ve highlighted previously. For male fittings, a different tool is required.
Made specifically for male aluminum or steel 37-degree flare fittings (more than just AN fittings) the Fitting Fixer consists of an alignment sleeve that threads onto the fitting in order to align the flare with the tool, and the driven lapping tool. Machined to a precise 37-degree inverted cone, the lapping tool is coated with diamond dust and fitted to a hexagonal shaft, allowing it to be chucked up in a hand drill or tap handle.
Repairing a fitting is a simple affair. Simply thread the fitting into the alignment collar, apply a small amount of lubricant into the abrasive cone, and then insert it into the opposite end of the sleeve. The trick here is to vary the direction of spin, not applying too much pressure for extended periods. This is simply to prevent aluminum build-up in the abrasive cone, as it can be difficult to remove once it clogs the abrasive grit. But, should you clog the abrasive, careful application of oven cleaner or muriatic acid can eliminate the aluminum from the grit.
While the Fitting Fixer is designed to repair fittings that have been knicked, dinged, or otherwise have their mating surface compromised, we discussed another potential use with the Fitting Fixer’s inventor, Dick Raczuk. We’ve noticed that with the influx of inexpensive fittings on the market, the quality of the anodizing can be questionable. We have run into more instances of brand-new fittings leaking right out of the package than ever before. When we asked about using the Fitting Fixer (and Sureseat) on new fittings, just as a matter of course, he was positive on the idea.
Pre-lapping the mating surfaces removes any potential imperfections right out of the gate, and ensures a perfect seal every time. While this step certainly isn’t required with quality AN fittings, it doesn’t hurt anything, either. And if you are using fittings of unknown or dubious origin, a little preemptive lapping can prevent any potential leaks before they start.
Unlike the Sureseat, the Fitting Fixers are size specific, ranging from 3/8-inch (-3 AN) to 1 inch (-16 AN) and are available individually or as part of a set. With the cost of larger fittings as well as replacements usually carrying a wait time, being able to repair a damaged fitting is the quicker and more economical option. Thanks to the Fitting Fixer, there is now an effective option to replacement.